Meyer Sound SIM 3 User's Guide Page 48
- Page / 232
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
42
CHAPTER 2
The SIM 3 Hardware
2.4.1. Front Panel
The front panel features the following switches and LEDs:
Power
± 15 V
SIM 3 Remote Power Supply
(1) (2)
Connect to
3022 Analyzer ONLY
Connect to
3088 or 3081 ONLY
WARNING:
Do not connect
3022 Analyzer to
this connector.
Damage will occur.
200 -
250
100 -
125
V-Range
115/230 V-
50/60 Hz
25 W Max
250mA 250 V
SIM 3 Remote Power Supply
(1)
(2)
(3) (4)
(5)
(1) Push-type power switch (2) Power on LED, +/-15 V
2.4.2. Rear Panel
All connections to the power supply are on the rear panel. Supply AC power and connect to
the SIM analyzer and switchers using SIM bus connector cables. The connectors and their
functions are described below.
Power
± 15 V
SIM 3 Remote Power Supply
(1) (2)
Connect to
3022 Analyzer ONLY
Connect to
3088 or 3081 ONLY
WARNING:
Do not connect
3022 Analyzer to
this connector.
Damage will occur.
200 -
250
100 -
125
V-Range
115/230 V-
50/60 Hz
25 W Max
250mA 250 V
SIM 3 Remote Power Supply
(1)
(2)
(3) (4)
(5)
(1) SIM Bus Connector, connect to SIM-3022 analyzer or to a previous switcher connected
to the analyzer – DC power is blocked.
(2) SIM Bus Connector, connect to SIM-3088 line switcher or SIM-3081 mic switcher
– provides DC power.
(3) Recessed voltage switch, two ranges of 100 – 125 V AC and 200 – 250 V AC.
(4) 250 mA / 250 V fuse
(5) AC power connector, 3-pin IEC style
CAUTION: Set the unit to the appropriate voltage range and make the AC
connection. The power supply will be able to perform at its full capabilities
when the AC power is kept in the ranges of 110 – 125 V or 220 – 250 V, 50/60 Hz.
- USER GUIDE 1
- INTEGRATION TOOLS 1
- Office of Quality Manager 2
- Berkeley, California USA 2
- December 1, 2005 2
- SYMBOLS USED 3
- IMPORTANT SAFETY INSTRUCTIONS 4
- CONTENTS 5
- INTRODUCTION TO THIS MANUAL 7
- CHAPTER 1 10
- SIM 3 Measurement Terminology 10
- 2.1.1.5. Line Inputs 1 and 2 21
- 2.1.1.7. Headphone Output 25
- Device Under Test 26
- CHAPTER 2 27
- The SIM 3 Hardware 27
- 2.1.2.1. AC Connector 28
- 2.2. SIM-3088 LINE SWITCHER 32
- 2.2.1. Front Panel 32
- Bus Select 36
- 2.2.4.2. Audio Connections 39
- 2.3.2. Rear Panel 45
- SIM-3022 Audio Analyzer 46
- 2.4.1. Front Panel 48
- 2.4.2. Rear Panel 48
- 3.1. SETTING UP BRANCHES 57
- 3.1.1. Overview 57
- 3.1.2. Defining Branches 57
- CHAPTER 3 58
- 4.4.1.1. System Requirements 78
- CHAPTER 4 80
- Software Updating 80
- 4.4.2.2. Opening a Project 81
- 4.4.3. Viewing Data 86
- 5.1.3. Console 92
- 5.1.4. Processor 92
- 5.1.5. Microphone 92
- 5.1.6. All 92
- 5.2. LINE SPECTRUM 93
- 5.2.1. Overview 93
- 5.2.3. Console 94
- 5.2.4. Processor 94
- 5.2.5. Microphone 94
- 5.2.6. All 95
- 5.3. DELAY FINDER 95
- 5.3.1. Overview 95
- 5.4. FREQUENCY RESPONSE 99
- 5.4.1. Overview 99
- CHAPTER 5 100
- The Measurements 100
- 5.4.6. Group 101
- 5.4.3. Room 101
- 5.4.4. Processor 101
- 5.4.5. Result 101
- 102
- 6.1. OVERVIEW 103
- 6.2. GRAPH WINDOWS 103
- CHAPTER 6 107
- The SIM Measurement Screen 107
- 6.5. NAMES TAB 111
- 6.6. VALUES TAB 111
- 6.8. DELAYS TAB 115
- 6.9. SPEAKERS TAB 115
- CHAPTER 7 129
- Using SIM 3 129
- 7.2.5. Average Time 132
- 7.2.6. Time Weighting 132
- 7.4.2. Storing Measurements 143
- 7.4.6. Recalling Measurements 147
- 7.4.7. Renaming Measurements 148
- 7.4.8. Sorting Measurements 149
- 7.6.1. Overview 157
- 7.6.3.1. Setup 158
- 7.6.3.3. Delay Finder 158
- 7.7.4. Turning Traces On/Off 160
- 7.7.5. Using Trace Offset 160
- 7.8.1. EQ Overview 164
- 7.10.5. Setting Meter Ranges 171
- 7.12.6. Mic EQ 178
- 7.12.7. Console Check 178
- 7.13. PERFORMING PROCEDURES 180
- 7.13.1. Mic SPL Calibration 180
- 7.13.2. Check Noise 182
- 7.13.3. Check Max Output 182
- 7.13.4. Verify Polarity 182
- 7.13.7. Set System Level 186
- 7.13.8. Set System EQ 187
- 8.1.11. Eject CD 194
- 8.2. VIEW 194
- 8.2.1. View Cursor 194
- 8.2.5. Spectrum Max 196
- 8.2.6. Spectrum Max Hold 196
- 8.2.7. Band Spectrum Solid 197
- 8.2.8. Vertical Zoom 197
- 8.2.9. Horizontal Zoom 197
- 8.2.10. Processor Inverted 198
- 8.2.11. Phase Center at Zero 198
- 8.2.12. Show Coherence as SN 199
- 8.2.13. Smoothing 199
- 8.2.14. Trace Offsets 199
- 8.3. BRANCH 200
- 8.3.1. Edit Branches 200
- 8.3.2. Previous Branch 200
- 8.3.3. Next Branch 201
- 8.3.4. Branch 0 – Branch 32 201
- 8.4. SETTINGS 201
- 8.4.1. Switchers 201
- 8.4.6. Delay Finder Settings 203
- 8.4.8. Input Panel Settings 203
- 8.4.9. Mouse Settings 205
- 8.4.10.Time and Date 205
- 8.5. MODE 205
- 8.5.1. Free Run 205
- 8.5.2. Single System 205
- CHAPTER 8 206
- SIM 3 Menus 206
- 8.7.2. Store DataGroup 209
- 8.7.3. Recall DataGroup 209
- 8.7.4. Clear 209
- 8.7.5. Pause 209
- 8.7.6. Live 210
- 8.7.7. Memory A – Memory D 210
- 8.7.9. Room Offset +/-1 dB 210
- 8.7.10. QuickStore 210
- 8.8. GENERATOR 211
- 8.8.1. Pink Noise (Nz) 211
- 8.8.2. Sine Wave (Sine) 211
- 8.8.3. Pulse (Pls) 211
- 8.9. TABS 211
- 8.10. HELP 213
- 8.10.1. About SIM 3 213
- 8.10.2. Contents 213
- APPENDIX A: SPECIFICATIONS 215
- APPENDIX A 216
- SIM 3 Specifications 216
- APPENDIX B 218
- APPENDIX C 221
- Extended Table of Contents 221
Related products and manuals for Laptops Meyer Sound SIM 3
Laptops Meyer Sound SIM 3 User Manual
(20 pages)
(20 pages)
Laptops Meyer-sound SIM 3 User Manual
(18 pages)
(18 pages)
© 2020, manymanuals.com. All rights reserved. | 0.448 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals