130
CHAPTER 7
Using SIM 3
Figure 7.10. Group view in Frequency Response, using 8 averages
TIP: With measurements that are likely to be steady-state, such as of an
equalizer, console, or other electronic device, a lower number of averages is
often sufficient. As fast as SIM 3 is, using a higher number of averages does not take
a significant amount of time, and the default is 8 averages.
7.3.5. Using Delay Finder & AutoSet Delay
Delay Finder and Autoset Delay have been discussed in previous sections, so this section will
briefly go through how to use these tools while making a measurement. See “AutoSet Delay
(F3)” in section 7.2.7, and the description of Delay Finder in section 5.3 of “Measurements”
for more information.
After levels and the number of averages have been set, and a Live Branch has been selected,
click on the Delay Finder tab and go to that measurement.
1. Processor: See if any delay has been introduced through that part of the signal chain.
If so, click the Autoset Delay button to set the internal delay in SIM for the processor in
this branch.
Comments to this Manuals