Meyer Sound M'elodie M Series Operations Instructions Page 35

  • Download
  • Add to my manuals
  • Print
  • Page
    / 44
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 34
29
CHAPTER 7
CAUTION: Do not exceed five M’elodie
cabinets high to avoid tipping over the stack.
CAUTION: Avoid moving the M’elodie
stack in the front-to-back direction of the
loudspeakers (the long side); always move the stack
sideways to avoid tipping it over.
STOW
STOW
A
B
A
B
GROUND S TACK
FRONT LIN K
GROUND S TACK
REAR LIN K
MAXIMU M DOWN-TILT
MAXIMU M UP-TILT
B A
B B
-5º
A B
-10º
FRONT
LINK
REAR
LINK
RESULT
ANGLE
-5º
MG-M’E LODIE
B
A
STOW
Berkeley, CA
SEE MG-M’ELODIE ASSEMBLY GUIDE FOR ADDITIONAL LOAD
RATINGS AND RIGGING SAFETY INFORMATION.
DO NOT EXCEED
GRID TILT
CAUTION: DO NOT EXCEED LOAD RATING
PRECAUTION: NO EXCEDER LIMITE DE CARGA
ATTENTION: N'EXCEDEZ PAS L'ESTIMATION DE CHARGE
VORSICHT: UBERSTEIGEN SIE NICHT LAST BEWERTUNG
5:1 7:1
LOAD RATINGS
1550 lbs
702 kg
(25 M’elodie)
1116 lbs
506 kg
(18 M’elodie)
+/-60 DEG.
0
3
6
9
11
0
3
6
9
11
0
3
6
9
11
0
3
6
9
11
0
3
6
9
11
Figure 7.13. The M’elodie stack should only be moved sideways when being
transported on the MCF-M’elodie caster frame
The M’elodie GuideALinks allow multiple transport angles
with the MCF-M’elodie caster frame.
Use the 5 position on the M’elodie rear GuideALink to
get the first M’elodie with respect to the caster frame at
0 degrees. This setting is preferred when all M’elodies
are at 0 degrees.
Use the 0 position to downtilt the first M’elodie with
respect to the caster frame, to compensate if the rest of
the M’elodies in the stack have severe angles.
0
3
6
9
11
Figure 7.14. First M’elodie at 0 degrees (straight-up) with respect to the
MCF-M’elodie
0
3
6
9
11
Figure 7.15. First M’elodie at -5 degrees (downtilted) with respect to the
MCF-M’elodie
TIP: The MG-M’elodie can travel installed on
top of a M’elodie stack.
Use position 5
Use position 0
Page view 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 43 44

Comments to this Manuals

No comments