Meyer Sound UPJunior Operations Instructions download pdf (Page 32)

CHAPTER 7: THE RMS REMOTE MONITORING SYSTEM

THE RMS MODULE

The RMS module is installed in the bottom slot of the user

panel on the back of the Meyer Sound loudspeaker. The

RMS user panel has three LEDs, two buttons, and two Net-

work connectors.

NOTE: The LEDs and buttons on the RMS user

panel are used exclusively by RMS and have

no effect on the acoustical or electrical activity of the

UPJunior, unless Mute and Solo are enabled for the

loudspeaker.

Service LED (Red)

The red Service LED provides the following feedback:

■ When unlit, the loudspeaker is successfully connected to

the network and commissioned.

■ When blinking once every two seconds, the loudspeaker

is connected to the network but not yet commissioned in

the RMS software.

■ When lit continuously, the loudspeaker’s RMS hardware

has failed and may indicate that the module has been

damaged (contact Meyer Sound Technical Support).

Service Button

Pressing the Service button identifies the loudspeaker on

the RMS network and notifies the RMS software that the

loudspeaker is connected. When the Service and Reset but-

tons are pressed at the same time, the card is decommis-

sioned from the network and the red Service LED blinks.

Wink LED (Green)

The green Wink LED lights up when a signal is sent from the

RMS software by clicking the Wink button on the loud-

speaker’s icon or on its Text view. This is useful for identify-

ing the physical loudspeaker corresponding to a

loudspeaker icon in the RMS software.

Reset Button

Pressing the Reset button causes the RMS module’s firm-

ware to reboot; this will not affect whether the loudspeaker

is commissioned (which is stored in flash memory). When

the Reset and Service buttons are pressed at the same time,

the card is decommissioned from the network and the red

Service LED blinks.

Activity LED (Green)

The green Activity LED flashes continuously when the loud-

speaker has been successfully commissioned.

Network Connectors

The two bi-directional Weidmuller locking connectors trans-

fer data to and from the RMS network. Two connectors are

provided to allow for easy connection of multiple (daisy-

chained) loudspeakers on the network.

INSTALLING MUTE AND SOLO CAPABILITY

The RMS software allows you to remotely mute and solo

individual loudspeakers on the RMS network, which is use-

ful during setup and installation and for troubleshooting. To

use the mute and solo capability of any RMS-equipped

loudspeaker, a special jumper must be installed in the loud-

speaker’s RMS module (the jumper ships as a separate item

with the loudspeaker). The RMS software must also be con-

figured to enable mute and solo capability. RMS does not

provide control over loudspeaker volumes or AC power.

RMS Module

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 43 44

Comments to this Manuals

No comments

Meyer Sound UPJunior Operations Instructions Page 32

Comments to this Manuals

Related products and manuals for Portable speakers Meyer Sound UPJunior